Assembly wardrobe method steps and price introduction

[ Chinese wardrobe network ] Everyone knows that the current rental house is very small, and people can buy some simple assembled wardrobes online in order to get a very large storage space. There are a lot of things that can be stored under the assembled wardrobe, and the price of assembling the wardrobe is very cheap, but assembling the wardrobe looks very simple, but it is very troublesome to do. That Xiaobian will briefly introduce how to assemble the wardrobe and the price of assembling the wardrobe on the market.

Assembling wardrobe method

Check accessories

Open the package, and then check whether the accessories inside are complete. There is a manual, check the instructions. If there are few, it is estimated that you can't install it without using it. Therefore, the number of advances is clear, so as not to be wasted. When installing, be sure to wear gloves. And must read the instructions carefully.

First installed bottom

First install the bottom one, take out the four-way joint with the bottom and the high, and connect with the short tube in the middle. Install a four-way joint on each side, then install the tube on both sides, decide the position of the place, and install the long tube. Short tube. Then install the base cloth on both sides, then install a three-way joint around each other.

Set of wardrobe sets

After installing the bottom, insert six short steel pipes, and then put the whole wardrobe cloth up against the surrounding holes. Then install a layer of partition like the bottom, and then put it on the six steel pipes.

Short-story floor

If the wardrobe is divided on two sides, first install the short-side floor, first insert the side steel pipe, then install the cloth, then connect the four-way joint, then install two horizontal steel pipes, then install the cloth, then Then make up the four-way joint on both sides. Repeat the baffle until it is attached to the top.

Long steel pipe

After the short-side partition is installed, the long side is a vertical hanging area, and a three-way joint is used to connect the two long tubes to the top.

Top steel pipe

After the two sides are installed, connect them directly with long steel pipes, so that the wardrobe is installed. If the wardrobe is too high and not enough to squeeze, it is recommended to push the side backwards so as not to be installed. At the same time, the hanging steel pipe can also be used. The connector is installed, this is relatively simple.

Set of wardrobe sets

When the top of the big set is at the top, it is best to pull the bottom to the top, so that there is space to pull on the top until the corners are installed diagonally. At this time, the cloth cover can be pulled down. The wardrobe is installed. After that, I feel that the whole wardrobe is so big. It is more than a small series. It takes an hour to install it. As long as it is careful, it will not be wrong.

Assembly wardrobe price

If the rental house is small, you can only choose to open the door when you can only put a wardrobe after the bed is finished. You can use the assembled wardrobe to save space. The closet can be divided into several blocks, one can be used to hang clothes, one small drawer, one can put some sundries and so on. The price of the assembled wardrobe on the market is about 100 yuan (source network, for reference only).

With the rapid development of China's economy, the demand for young labor is increasing, and more and more young people are coming to the city. When young people come to Changshu to fight, they will rent a house. The houses rented by people to reduce expenses are very small. There is almost no place to put things apart from sleeping places. The appearance of the assembled wardrobe is that the utilization of the storage space is greatly increased.

Car Seat Accessories

Car Seat Accessories,Reclining Handle,5-Point Harness,Infant Carrier

NINGBO BABY FIRST BABY PRODUCTS CO.,LTD. , https://www.maxinfcarseat.com